Windows route add on-link

Please describe steps required to do it. What's the on-link for IPV6? You can add an interface using the command route add Jitender Kumar Jitender Kumar 11 1 1 bronze badge. Sign up or log in Sign up using Google. Sign up using Facebook. Sign up using Email and Password. Post as a guest Name. Email Required, but never shown. The Overflow Blog. Stack Gives Back Yep, the other three answers are correct: it's just a route that's directly reachable the NIC is in direct contact with it; on the same subnet.

To explain a little further though: by contrast, the routes that have a gateway IP listed must be contacted through that gateway. So, in the table you gave above, The destination machine would see the packet, and take it off the network directly. But to reach Note that I haven't bothered looking at the whole routing table to make sure there are no more specific routes overriding these, as it's a little beside the point for this issue. In general, such record will be generated after establishing a dial-up connection.

Sign up to join this community. The best answers are voted up and rise to the top. Stack Overflow for Teams — Collaborate and share knowledge with a private group. Create a free Team What is Teams? Learn more. What does "On-link" mean on the result of "route print" command? Ask Question.

Please rate your experience Yes No. Any additional feedback? Submit and view feedback for This product This page. View all page feedback. In this article. Clears the routing table of all entries that are not host routes routes with a netmask of If this is used in conjunction with one of the commands such as add, change, or delete , the table is cleared prior to running the command.

When used with the print command, the list of persistent routes is displayed. This parameter is ignored for all other commands. Specifies the command you want to run. The valid commands include: add - Adds a route. Here is quick guide to help you accomplish these tasks. To add a route to the routing table use the route add command. An example looks like this:. You can optionally add a metric 2 to the end if you want to add a specific weight to the route. The routes with the lowest metric will take precedence over higher metrics.

By default, static routes have a metric of 6.