Body tech 2 manual

You can enable it by going to Control Panel and clicking on bit Application Support then clicking Enable. Windows xp or Windows 7? If your laptop does not have a RS port, then will need to buy the needed usb cable to connect the Tech II to the laptop, and make sure to install the needed USB driver into the the XP shell as well.

It will last about 3 minutes. You will notice that the PC screen will display a blue progress bar as the software is uploading to the vehicle. The GM setup will not allow the same calibration to be reinstalled over itself.

Only an updated calibration can be loaded into the vehicle computer. All programming steps are activated and finalized through the PC. Note: If the TIS software was previous installed and removed from the PC, a message may appear asking to reuse old settings. This displays the Choose Destination Location window. You can optionally click the Browse button to select a different destination directory for the files.

This must be an open COM port where no external devices are connected. Then click the Next button. This configures settings, starts the. Other dealership installations are not supported. Then click the Continue button. This displays an Information window Figure 1. This displays a Hardware Installation message box. Note: During the update, the TIS software skips the initial language, dealership, etc. Because TIS looks for new updates each time you start the application, the Update message appears.

This begins the update and displays a progress indicator message. When the update completes, a completion message appears. Do one of the. CAUTION: There are a number of programming preparations that must be followed exactly or permanent damage to a reprogrammable control module could result:. What is TIS used for?

Where to get TIS cracked? How to install TIS? How to use TIS? Definition: What is TIS? Operating system: As for Tis, need to run under XP,.

Laptop requirement: If your laptop does not have a RS port, then will need to buy the needed usb cable to connect the Tech II to the laptop, and make sure to install the needed USB driver into the the XP shell as well.

Drivers are listed about half way down on the page. This displays the Language Selection window. This displays the Choose Serial Port window Figure 1. This displays the Program Completed window. Get the Manual Here. Donald posted an answer 9 years, 2 months ago.

I found this manual. Was this answer helpful? Yes No. Dick posted an answer 9 years, 1 month ago. Kelli posted an answer 10 years, 12 months ago. It is a clear sticker with green lettering a little hard to read so I think that is what it is.

If there is anybody that could help I would appreciate it. Lee posted an answer 11 years, 9 months ago. Lee posted an answer 12 years, 6 months ago.

I need the manual for Michelle posted an answer 6 years, 9 months ago. The previous owner allowedit to sit on the weather.